Amplite® Fluorimetric NADP Assay Kit *Blue Fluorescence*

1. Prepare NADP standards or test samples (50 µL)
2. Add 20 µL Quest Fluor™ NADP Probe
3. Add 20 µL Assay Solution
4. Incubate at RT for 10 - 20 minutes
5. Add 15 µL Enhancer Solution
6. Incubate at RT for 10 - 20 minutes
7. Monitor Fluorescence at 420/480 nm (Cutoff = 455 nm)

Thaw each kit components at room temperature before starting the experiment.

Unless otherwise noted, all unused stock solutions should be divided into single-use aliquots and stored at -20 °C after preparation. Avoid repeated freeze-thaw cycles

Add 500 µL of ddH₂O into the vial of NADP Standard (Component D) to make 1 mM NADP standard solution.

Table 1. Layout of NADP standards and test samples in a black/solid bottom 96-well microplate. NS=NADP standards (NS1-NS7, 0.01 to 10 µM); BL= blank control; TS=test sample.

Table 2. Reagent composition for each well.

1. Prepare NADP standards (NS), blank controls (BL), and test samples (TS) according to the layout provided in Table 1 and Table 2. For a 384-well plate, use 25 µL of reagent per well instead of 50 µL.
2. Add 20 µL Quest Fluor™ NADP Probe (Component A) solution into each well of NADP standard, blank control, and test samples, mix well. For a 384-well plate, use 10 µL of Quest Fluor™ NADP Probe (Component A) solution instead.
3. Add 20 µL Assay Solution (Component B) into each well, mix well. For a 384-well plate, use 10 µL of Assay Solution (Component B) instead.
4. Incubate the reaction at room temperature for 10 - 20 minutes, protected from light.
5. Add 15 µL Enhancer (Component C) to each well to make the total NADP assay volume of 105 µL/well. For a 384-well plate, add 7.5 uL Enhancer (Component C) instead, for a total volume of 52.5 µL/well.
6. Incubate at room temperature for 10 - 20 minutes, protected from light.
7. Monitor the fluorescence increase with a fluorescence plate reader at 420/480 nm (Cutoff = 455nm).