LysoBrite™ Orange

1. Prepare cells.

2. Add dye working solution.

3. Incubate at 37 °C for 30 minutes.

4. Wash the cells.

5. Analyze under a fluorescence microscope.

The LysoBrite™ Orange stock solution provided is 500X in DMSO. It should be stable for at least 6 months if stored at -20°C. Protect from light and avoid freeze/thaw cycles.

1. Warm LysoBrite™ Orange dye to room temperature.

2. Prepare dye working solution by diluting 20 µL of 500X LysoBrite™ Orange with 10 mL of Hanks and 20 mM HEPES buffer (HBSS) or buffer of your choice.

   Note: 20 µL of LysoBrite™ Orange dye is enough for one 96-well plate. Aliquot and store unused LysoBrite™ dye stock solutions at < -15 °C. Protect it from light and avoid repeated freeze-thaw cycles.

   Note: The optimal concentration of the fluorescent lysosome indicator varies depending on the specific application. The staining conditions may be modified according to the particular cell type and the permeability of the cells or tissues to the probe. 

This protocol only provides a guideline and should be modified according to your specific needs.

1. Grow cells in a 96-well black wall/clear bottom plate (100 µL/well/96-well plate) or on coverslips inside a petri dish filled with the appropriate culture medium.

2. When cells reach the desired confluence, add an equal volume of the dye-working solution (from Preparation of Working Solution Step 2). 

3. Incubate the cells in a 37 °C, 5% CO2 incubator for 30 minutes.

4. Wash the cells twice with pre-warmed (37 °C) Hanks and 20 mM HEPES buffer (HBSS) or buffer of your choice. Then fill the cell wells with HBSS or growth medium.

5. Observe the cells using a fluorescence microscope fitted with the desired filter set.

   Note: It is recommended to increase either the labeling concentration or the incubation time to allow the dye to accumulate if the cells do not appear to be sufficiently stained.

1. Add an equal volume of the dye-working solution (from Preparation of Working Solution Step 2). 

2. Incubate the cells in a 37 °C, 5% CO2 incubator for 30 minutes.

3. Wash the cells twice with pre-warmed (37 °C) Hanks and 20 mM HEPES buffer (HBSS) or buffer of your choice. Then fill the cell wells with HBSS or growth medium.

4. Observe the cells using a fluorescence microscope fitted with the desired filter set.

   Note: It is recommended to increase either the labeling concentration or the incubation time to allow the dye to accumulate if the cells do not appear to be sufficiently stained.

   Note: Suspension cells may be attached to coverslips treated with BD Cell-Tak® (BD Biosciences) and stained as adherent cells (see Protocol for Preparing and Staining Adherent Cells).